Size of frame too large

[Franky (Frank Legame - Win10-11 - PL8 - FP7 - VP5 - NC7 - Sony α)]

Hi,
I just tested and i think there is a problem.
I set the slider to 0 and the thickness is too large.

[Egregius ([Greg] (Micro 4/3 + Win11))]

Unfortunately, that’s how it is by design. The matter has been raised before, in the following threads and elsewhere.

Please Update Frames in FilmPack

I use FilmPack with DxO PhotoLab, but I avoid the Frames because the minimum size setting leaves a frame that is too large. The slider should have 0-size as a minimum. Thanks. Bob

Poor Frame control in FilmPack

Working with the EA version of PhotoLab indicates there will be significant improvements that will allow us to do most of our necessary processing in DxO products. One flaw for those of us who use frames/borders is the screwy frame width control in FilmPack. [Frame] The frame-width control has numbers settings which go to “0”. Logically, the “0” setting should eliminate the frame entirely. But no, the “0” setting and other low numbers on this adjustment seem to have no effect whatsoever. As …

[uncoy (Alec Kinnear)]

Yes, it seems to me the minimum frame width should be about half as thick as what I see in this example. Less than that would become non-useful (i.e. just remove the frame).

[Franky (Frank Legame - Win10-11 - PL8 - FP7 - VP5 - NC7 - Sony α)]

Thanks
Yes the 0 is much too large and half would be fine
And then between 0 and 5 it doesn’t move.