Je n’ai pas tout compris dans ce qui précède…
Si la qestion est d’imprimer directement depuis PhotoLab sur une imprimante photo personnelle, c’est simple :
Dans le module d’impression :
- choisir l’imprimante et aller dans les propriétés de l’imprimante.
- dans les propriétés de l’imprimante, choisir le type et la taille du papier, et les diverses options (marge, etc). Il faut impérativement désactiver la gestion des couleurs propre à l’imprimante.
- de retour dans le module d’impression de PL, choisir la résolution (300 dpi par défaut).
- Profil couleur : Géré par DxO PhotoLab
- Choisir ensuite le profil ICC correspondant au PAPIER utilisé. Ce profil peut être fourni soit par le fabricant de l’imprimante (installé généralement en même temps que l’imprimante), soit par le fabricant du papier (téléchargeable sur son site)
- enfin choisir l’intention de rendu (généralement Perceptuel).
- On peut choisir la netteté, la valeur par défaut (50) étant une bonne base.
Si l’écran est bien étalonné (et l’imprimante correctement réglée), on doit normalement obtenir une impression parfaitement conforme à l’écran pour les couleurs… à condition de l’éclairer avec un illuminant “lumière du jour” (5000 °K environ)
I did not understand everything in the above …
If the question is to print directly from PhotoLab on a personal photo printer, it’s simple:
In the print module:
- choose the printer and go to the printer properties.
- in the printer properties, choose the type and size of the paper, and the various options (margin, etc.). It is imperative to deactivate the color management specific to the printer.
- back in the PL printing module, choose the resolution (300 dpi by default).
- Color profile: Managed by DxO PhotoLab
- Then choose the ICC profile corresponding to the PAPER used. This profile can be provided either by the printer manufacturer (usually installed at the same time as the printer), or by the paper manufacturer (downloadable from its site)
- finally choose the rendering intent (generally Perceptual).
- You can choose the sharpness, the default value (50) being a good basis.
If the screen is well calibrated (and the printer correctly adjusted), we should normally obtain a perfectly conforming printing to the screen for colors … provided that it is illuminated with a “daylight” illuminant (5000 ° K approximately)