DxO Forum

English forums => DxO OpticsPro (Windows) => Topic started by: Mack on June 06, 2018, 07:51:04 pm

Title: Windows 10-64 installation difficulty of PhotoLab update.
Post by: Mack on June 06, 2018, 07:51:04 pm
Having an issue trying to do the update in Windows 10-64 latest version to latest PhotoLab.

Program will not install with this:

"DxO PhotoLab Setup Wizard ended prematurely because of an error. Your system has not been modified.  To install this program at a later time, run Setup Wizard again.  Click the Finish button to exit the Setup Wizard."

Ideas?

I switched off Windows Anti-Virus and it acts like it is going to install, and then some pop-up saying:

"There was an error creating a temporary file that is needed to complete this installation." and it rolls back and uninstalls itself completely even from desktop.

Tia.



Title: Re: Windows 10-64 installation difficulty of PhotoLab update.
Post by: Bencsi on June 06, 2018, 10:53:54 pm
Have a look on the file c:\Users\YOUR_USER_NAME\AppData\Local\Temp\photolab1_install_log.log
Hopefully you will see some entries with the word "error".

By the way, if the temporary file creation was the source of the trouble, you should check the size of Windows scratch drive. It is 128 MB as default only, but some application stop when reach the limit. The drive is on your OS hardware as a separate partition called Data. To increase its size, you have to designate a drive letter first, then you can extend the size. My actual size is ~1GB and did not experienced any trouble anymore.

Endre